-
Migrate customization from AS2011 to AS2012
Hello to everyone who might be following this thread,
if the message A valid CAD platform has not been found (either it is not installed or the license is not valid) pops up. Before assuming something went horrible wrong deep down in Advance Steel, go to Advance Manager, Options. At the very bottom, make sure the correct setting is activated regarding using AutoCAD or standalone application. That was my problem.
Thanks again to everyone who responded to my posts.
-
Migrate customization from AS2011 to AS2012
Hi Phillippe,
yes that folder is present and with content.
Thanks
-
Surface Area for Plates
Hello,
I was wondering if it's possible to show plate/sheet surface area for one side only. Currently the lists show for all sides (paint). For example a 60"x120" would show a surface area of 7200 sq. in. Our purchaser orders all the sheet material by the square inches not by weight. It always is a hassle to calculate the sheet area from the weight.
Thanks
-
Migrate customization from AS2011 to AS2012
Ok, so I copied the modified files into AS2012.
Now when I try to start AS2012 I get this error message:
A valid CAD platform has not been found (either it is not installed or the license is not valid).
But it was running before that!
Thanks
-
Migrate customization from AS2011 to AS2012
Do I still have to copy AstorAddIn, symbols and prototypes from AS2011 into AS2012?
Thanks again
-
Migrate customization from AS2011 to AS2012
I was wondering what the process is to migrate my custom settings from AS2011 to AS2012. AS2012 doesn't have the Management Tool so I am assuming there is a different way to do it.
Thanks,
Dennis
-
After opening Excel on WIN7, 64 bit, Advanced Steel fails with odbcji32.dll type errors when trying to open. Exact same error result on all machines.
Hi Joseph,
were you able to resolve this issue?
Dennis
-
Advance Steel 2012 Multithread?
Howdy,
I was wondering if the standalone version of Advance Steel 2012 is going to support multithread or singlethread (as in AutoCAD where you can use only one processor).
Thanks,
-
Viewing bolts in GA and ISO views
Not sure if my problem is the same. But when I create a section showing a weld plate, the anchor bolts don't show up. I wonder if there is a setting to control visibility of anchors.
Any ideas?